![](https://lemm.ee/pictrs/image/025c85ca-3368-47c3-bbb2-1ea8be7e9cef.webp)
![](https://beehaw.org/pictrs/image/fed50129-04e7-4dbc-8f54-4ba5bae58370.png)
Soldering should be fine, this will probably end up as long winter evening project at some point. Was it possible to re-use gliders after dismembering the mouse?
Swelling problem won’t be fixed as easy. The material of the wheel just expanded, the rubber is twice as big as new one to the point it can’t fit in its hole in the mouse. Internet is full of the same problems, it was either defective batch or it reacts with some specific agent in some people’s sweat. Never the less, the only way is to replace the whole wheel. Need to find out which of my friends have a 3D printer…
I have two problems with this.